2008 Yamaha Fz1 Service Manual Pdf

Right handlebar switch lead O. Intake air pressure sensor coupler Disconnect. If the continuity reading is incorrect, check the wiring connections and if necessary, replace the switch. When installing oil seals, lubricate the oil seal lips with a light coat of lithium-soap-based grease. Measure the intake air temperature sensor resistance.

Any reproduction or unauthorized use without the written permission of Yamaha Motor Co. Illustration pages Yamaha bond No. Crankcase mating surface Yamaha bond No.

WORKSHOP MANUALS

Secure the left handlebar P. Engine trouble warning light off d. Symptom spheric pressure sensor voltage and intake air pressure sensor voltage differ greatly. Cranking the tion sensor engine. Clean the connecting rod bolts.

Using other brake pipes, hoses and union bolts may close the brake hose lines. Check the steering head for looseness or binding by turning the front fork all the way in both directions. Use oil and grease recommended by Yamaha for all lubrication jobs. Before measuring the fork oil level, wait ten minutes until the oil has settled and the air bubbles have dispersed. Neutral switch connector Disconnect.

If the heavy spot does not stay in that posi- mark is positioned as shown. Check the test coupler located in the left inner panel front cowling. This is not a malfunction. Clutch cable Clutch cover Clutch cover gasket Dowel pin Oil filler cap For installation, reverse the removal proce- dure.

Post navigation

Tightening torque specifications for spe- cial components or assemblies are provided for each chapter of this manual. Cylinder identification sensor coupler Disconnect. Drive chain guard Drive chain For installation, reverse the removal proce- dure. Headlight sub-wire harness coupler Disconnect. If faulty, indesign hyperlinks not working in pdf replace with a new one.

Apply compressed air to the rear of the radiator. Fuel sender coupler Disconnect.

Yamaha workshop manuals for download free2008 yamaha fz1 service manual pdf

If the bat- tery voltage is lower, recharge the battery. When there is neg- ative pressure at the exhaust port, the reed valve opens, allowing secondary air to flow into the exhaust port.

To secure the valve cotters onto the valve stem, lightly tap the valve tip with a soft- face hammer. This information will be needed to order spare parts. Disconnect the spark plug cap from the spark plug.

Best SellersMAINTENANCE

Oil level switch connector Disconnect. Tighten the connecting rod bolts. First edition, December All rights reserved.

MAINTENANCE

Less slippery road surface a. Front fender Cap bolt Loosen. Install the exhaust and intake camshafts, d. Turn the crankshaft clockwise. Standard key registration erases the stored standard key code from the memory, thus dis- abling the lost standard key.

Post navigation

Wheel axle nut Washer Rear wheel axle Adjusting block left Adjusting block right Rear wheel Brake caliper bracket For installation, reverse the removal proce- dure. Press down in the spacer with the fork h. Drive chain guard Drive chain For installation, reverse the removal procedure.

Lower the front wheel so that it is on the ground. Make sure that the current is higher than battery overheating and battery plate the standard charging current written on damage. Immobilizer system indicator light stops e.

In this case, make sure to replace the con- necting rod bolt. Hook the cover pawl to the fuel tank bracket. Main and ignition Replace the fuse s.

Sub-throttle position sensor coupler Disconnect. Measure the air induction system solenoid resistance. Do not attempt to disassemble it.

Licence plate light lead coupler Disconnect. Apply the specified pressure for ten sec- onds and make sure there is no drop in pressure. Disconnect the test coupler adapter from the test coupler, and install the protective cap with the test coupler adapter.

Diagnostic monitor- Sub-throttle servo motor ing code No. The following procedure applies to all of the clutch springs.